www.TeachEngineering.org: Free Curriculum for K-12

Navigation satellites are like orbiting landmarks. Rather than seeing these landmarks with our eyes, we "hear" them using radio signals. The Global Positioning System is a constellation (or set) of at least 24 satellites that continuously transmit faint radio signals toward the earth. These radio signals carry information about the location of the satellite and special codes that allow someone with a GPS receiver to measure distance to the satellite. Combining the distances and satellite locations, the receiver can find its latitude, longitude, and height. GPS satellite signals are free and available for anyone to use. GPS receivers are decreasing in cost every year and can be found in sporting good stores, are embedded in cell phones and even in watches.

How does a GPS receiver know how far away the satellites are? Early on, scientists recognized the principle that, given velocity and the time required for a radio signal to be transmitted between two points, the distance between the two points can be computed. In order to do this calculation, a precise, synchronized time of departure and measured time of arrival of the radio signal must be obtained. By synchronizing the signal transmission time to two precise clocks, one in a satellite and one at a ground-based receiver, the transit time could be measured and then multiplied by the exact speed of light to obtain the distance between the two positions.

GPS is based on satellite ranging. Our position on earth is calculated by measuring our distance from a group of satellites in space. This is done by timing how long it takes a radio signal to reach us from a satellite. The signal travels at the speed of light (186,000 miles per second), so we are able to calculate the distance (Velocity x Time = Distance. For more information, you may refer to the explanation of Dead Reckoning in Lesson 2 of this unit).

A diagram illustrating how Global Positioning System works.

Figure 2. How GPS works.
click for copyright

GPS satellite ranging allows a receiver to determine its 3-dimensional position: latitude, longitude and height. Because the ranging measurements are based on timing, both the time in the satellite transmitter and the user's receiver have to be coordinated. A GPS receiver measures range to four satellites to determine latitude, longitude, height and this timing correction.

Let's take this one step at a time. For now, assume that the satellite and receiver clocks are already coordinated, and the positions of the satellites are known. If we measure distance to one satellite, we know that we are located on a sphere of that radius, centered on the satellite. With two satellite range measurements, our location is limited to a circle and with three satellites to one of two points. A fourth satellite can be used to find the correct point and to take care of the time coordination.

If it has extra information, a receiver can figure out its position with fewer satellites. For example, if you know that you are on the ocean surface, you can use this piece of information and only three satellites to find your latitude, longitude, and timing. In this case, height is not needed because you already know it.

So, how do we know where the satellites are? All satellites are constantly monitored. They have a 12-hour orbit, and the U.S. Department of Defense is able to monitor the satellites from ground stations around the world. The satellites are checked for errors in their position, height, and speed. These minor errors are caused by gravitational pulls from the moon, sun, and even pressure from solar radiation on the satellite. The satellites transmit special codes for timing purposes, and these codes carry a data message about their exact location. This helps to locate the satellite precisely.